openssl/crypto/modes/asm/ghash-ia64.pl

238 lines
6.8 KiB
Perl
Raw Normal View History

#!/usr/bin/env perl
# ====================================================================
# Written by Andy Polyakov <appro@openssl.org> for the OpenSSL
# project. The module is, however, dual licensed under OpenSSL and
# CRYPTOGAMS licenses depending on where you obtain it. For further
# details see http://www.openssl.org/~appro/cryptogams/.
# ====================================================================
#
# March 2010
#
# The module implements "4-bit" GCM GHASH function and underlying
# single multiplication operation in GF(2^128). "4-bit" means that it
# uses 256 bytes per-key table [+128 bytes shared table]. Streamed
# GHASH performance was measured to be 6.35 cycles per processed byte
# on Itanium 2, which is >90% better than Microsoft compiler generated
# code. Well, the number should have been ~6.5. The deviation has
# everything to do with the way performance is measured: as difference
# between GCM and straightforward 128-bit counter mode. To anchor to
# something else sha1-ia64.pl module processes one byte in 6.0 cycles.
# On Itanium GHASH should run at ~8.5 cycles per byte.
# Note about "528B" variant. In Itanium 2 case it makes lesser sense
# to implement it for following reason. Because number of functional
# units is naturally limited, it's impossible to implement "528B" loop
# in 4 cycles, only in 5. This means that theoretically performance
# improvement can't be more than 20%, ~15% is more realistic. This
# is considered below justification level for implementing new code.
# Not to mention that on original Itanium it would actually run
# slower, spending >9 cycles per byte.
$output=shift and (open STDOUT,">$output" or die "can't open $output: $!");
if ($^O eq "hpux") {
$ADDP="addp4";
for (@ARGV) { $ADDP="add" if (/[\+DD|\-mlp]64/); }
} else { $ADDP="add"; }
for (@ARGV) { $big_endian=1 if (/\-DB_ENDIAN/);
$big_endian=0 if (/\-DL_ENDIAN/); }
if (!defined($big_endian))
{ $big_endian=(unpack('L',pack('N',1))==1); }
sub loop() {
my $label=shift;
my ($p16,$p17)=(shift)?("p63","p63"):("p16","p17"); # mask references to inp
# Loop is scheduled for 6 ticks on Itanium 2 and 8 on Itanium, i.e.
# in scalable manner;-) Naturally assuming data in L1 cache...
# Special note about 'dep' instruction, which is used to construct
# &rem_4bit[Zlo&0xf]. It works, because rem_4bit is aligned at 128
# bytes boundary and lower 7 bits of its address are guaranteed to
# be zero.
$code.=<<___;
$label:
{ .mfi; (p18) ld8 Hlo=[Hi[1]],-8
(p19) dep rem=Zlo,rem_4bitp,3,4 }
{ .mfi; (p19) xor Zhi=Zhi,Hhi
($p17) xor xi[1]=xi[1],in[1] };;
{ .mfi; (p18) ld8 Hhi=[Hi[1]]
(p19) shrp Zlo=Zhi,Zlo,4 }
{ .mfi; (p19) ld8 rem=[rem]
(p18) and Hi[1]=mask0xf0,xi[2] };;
{ .mmi; ($p16) ld1 in[0]=[inp],-1
(p18) xor Zlo=Zlo,Hlo
(p19) shr.u Zhi=Zhi,4 }
{ .mib; (p19) xor Hhi=Hhi,rem
(p18) add Hi[1]=Htbl,Hi[1] };;
{ .mfi; (p18) ld8 Hlo=[Hi[1]],-8
(p18) dep rem=Zlo,rem_4bitp,3,4 }
{ .mfi; (p17) shladd Hi[0]=xi[1],4,r0
(p18) xor Zhi=Zhi,Hhi };;
{ .mfi; (p18) ld8 Hhi=[Hi[1]]
(p18) shrp Zlo=Zhi,Zlo,4 }
{ .mfi; (p18) ld8 rem=[rem]
(p17) and Hi[0]=mask0xf0,Hi[0] };;
{ .mmi; (p16) ld1 xi[0]=[Xi],-1
(p18) xor Zlo=Zlo,Hlo
(p18) shr.u Zhi=Zhi,4 }
{ .mib; (p18) xor Hhi=Hhi,rem
(p17) add Hi[0]=Htbl,Hi[0]
br.ctop.sptk $label };;
___
}
$code=<<___;
.explicit
.text
prevfs=r2; prevlc=r3; prevpr=r8;
mask0xf0=r21;
rem=r22; rem_4bitp=r23;
Xi=r24; Htbl=r25;
inp=r26; end=r27;
Hhi=r28; Hlo=r29;
Zhi=r30; Zlo=r31;
.global gcm_gmult_4bit#
.proc gcm_gmult_4bit#
.align 128
.skip 16;; // aligns loop body
gcm_gmult_4bit:
.prologue
{ .mmi; .save ar.pfs,prevfs
alloc prevfs=ar.pfs,2,6,0,8
$ADDP Xi=15,in0 // &Xi[15]
mov rem_4bitp=ip }
{ .mii; $ADDP Htbl=8,in1 // &Htbl[0].lo
.save ar.lc,prevlc
mov prevlc=ar.lc
.save pr,prevpr
mov prevpr=pr };;
.body
.rotr in[3],xi[3],Hi[2]
{ .mib; ld1 xi[2]=[Xi],-1 // Xi[15]
mov mask0xf0=0xf0
brp.loop.imp .Loop1,.Lend1-16};;
{ .mmi; ld1 xi[1]=[Xi],-1 // Xi[14]
};;
{ .mii; shladd Hi[1]=xi[2],4,r0
mov pr.rot=0x7<<16
mov ar.lc=13 };;
{ .mii; and Hi[1]=mask0xf0,Hi[1]
mov ar.ec=3
xor Zlo=Zlo,Zlo };;
{ .mii; add Hi[1]=Htbl,Hi[1] // &Htbl[nlo].lo
add rem_4bitp=rem_4bit#-gcm_gmult_4bit#,rem_4bitp
xor Zhi=Zhi,Zhi };;
___
&loop (".Loop1",1);
$code.=<<___;
.Lend1:
{ .mib; xor Zhi=Zhi,Hhi };; // modulo-scheduling artefact
{ .mib; mux1 Zlo=Zlo,\@rev };;
{ .mib; mux1 Zhi=Zhi,\@rev };;
{ .mmi; add Hlo=9,Xi;; // ;; is here to prevent
add Hhi=1,Xi };; // pipeline flush on Itanium
{ .mib; st8 [Hlo]=Zlo
mov pr=prevpr,-2 };;
{ .mib; st8 [Hhi]=Zhi
mov ar.lc=prevlc
br.ret.sptk.many b0 };;
.endp gcm_gmult_4bit#
.global gcm_ghash_4bit#
.proc gcm_ghash_4bit#
.align 32;;
gcm_ghash_4bit:
.prologue
{ .mmi; .save ar.pfs,prevfs
alloc prevfs=ar.pfs,4,4,0,8
$ADDP inp=15,in2 // &inp[15]
mov rem_4bitp=ip }
{ .mmi; $ADDP end=in3,in2 // &inp[len]
$ADDP Xi=15,in0 // &Xi[15]
.save ar.lc,prevlc
mov prevlc=ar.lc };;
{ .mmi; $ADDP Htbl=8,in1 // &Htbl[0].lo
mov mask0xf0=0xf0
.save pr,prevpr
mov prevpr=pr }
.body
.rotr in[3],xi[3],Hi[2]
{ .mmi; ld1 in[2]=[inp],-1 // inp[15]
ld1 xi[2]=[Xi],-1 // Xi[15]
add end=-17,end };;
{ .mmi; ld1 in[1]=[inp],-1 // inp[14]
ld1 xi[1]=[Xi],-1 // Xi[14]
xor xi[2]=xi[2],in[2] };;
{ .mii; shladd Hi[1]=xi[2],4,r0
mov pr.rot=0x7<<16
mov ar.lc=13 };;
{ .mii; and Hi[1]=mask0xf0,Hi[1]
mov ar.ec=3
xor Zlo=Zlo,Zlo };;
{ .mii; add Hi[1]=Htbl,Hi[1] // &Htbl[nlo].lo
add rem_4bitp=rem_4bit#-gcm_ghash_4bit#,rem_4bitp
xor Zhi=Zhi,Zhi };;
___
&loop (".LoopN");
$code.=<<___;
{ .mib; xor Zhi=Zhi,Hhi // modulo-scheduling artefact
extr.u xi[2]=Zlo,0,8 } // Xi[15]
{ .mib; cmp.ltu p6,p0=inp,end // are we done?
add inp=32,inp // advance inp
clrrrb.pr };;
{ .mii;
(p6) ld1 in[2]=[inp],-1 // inp[15]
(p6) extr.u xi[1]=Zlo,8,8 // Xi[14]
(p6) mov ar.lc=13 };;
{ .mii;
(p6) ld1 in[1]=[inp],-1 // inp[14]
(p6) mov ar.ec=3
mux1 Zlo=Zlo,\@rev };;
{ .mii;
(p6) xor xi[2]=xi[2],in[2]
mux1 Zhi=Zhi,\@rev };;
{ .mii;
(p6) shladd Hi[1]=xi[2],4,r0
add Hlo=9,Xi // Xi is &Xi[-1]
add Hhi=1,Xi };;
{ .mii;
(p6) and Hi[1]=mask0xf0,Hi[1]
(p6) add Xi=14,Xi // &Xi[13]
(p6) mov pr.rot=0x7<<16 };;
{ .mii; st8 [Hlo]=Zlo
(p6) xor Zlo=Zlo,Zlo
(p6) add Hi[1]=Htbl,Hi[1] };;
{ .mib; st8 [Hhi]=Zhi
(p6) xor Zhi=Zhi,Zhi
(p6) br.cond.dptk.many .LoopN };;
{ .mib; mov pr=prevpr,-2 }
{ .mib; mov ar.lc=prevlc
br.ret.sptk.many b0 };;
.endp gcm_ghash_4bit#
.align 128;;
.type rem_4bit#,\@object
rem_4bit:
data8 0x0000<<48, 0x1C20<<48, 0x3840<<48, 0x2460<<48
data8 0x7080<<48, 0x6CA0<<48, 0x48C0<<48, 0x54E0<<48
data8 0xE100<<48, 0xFD20<<48, 0xD940<<48, 0xC560<<48
data8 0x9180<<48, 0x8DA0<<48, 0xA9C0<<48, 0xB5E0<<48
.size rem_4bit#,128
stringz "GHASH for IA64, CRYPTOGAMS by <appro\@openssl.org>"
___
$code =~ s/mux1(\s+)\S+\@rev/nop.i$1 0x0/gm if ($big_endian);
print $code;
close STDOUT;